CAMERA LINK Q-2A340 Operating And Users Manual page 41

OPERATING AND USER MANUAL QUARTZ SERIES
8.1.3. Add a defect pixel to the defect pixel list
Defect pixel correction is maintained by a defect pixel list. An additional defect pixel can be added to
this list by means of the DP command.
Command format: DPx;y
Return Message: x;y
Where x and y are the origin (1, 1) base coordinates of the defect pixel.
Defect pixels can be queried ad follows:
Command format: DPn?
Parameter n indicates the index of the defect pixel list for querying defect coordinates.
If n=0 is queried, the number of defects in the list is returned.
8.1.4. Remove defect pixel
Defect pixels can be removed from the defect pixel list by means of the DPR command.
Command format:
Where x and y are the origin (1, 1) base coordinates of the defect pixel.
If the coordinate does not exist in the list, error 7 (parameter out of range) is issued (see section
11.1.2).
8.1.5. Clear defect pixel list
The defect pixel list can be cleared:
Command format: DPC
8.1.6. Restore factory default defect pixel list
The defect pixel list can be restored to its factory default by means of the DPFD command:
Command format: DPFD
NOTE: The later added coordinates in the defect pixel list will be lost.
8.1.7. Defect pixel test mode
The camera is able to display the defect pixel map as an overlay on the image.
This is an aid to visualize the defect pixel list in the image.
Command format: DPTn
Command format: DPT?
Return Message: n
42
DPRx;y