CAMERA LINK Q-2A340 Operating And Users Manual page 10

2.2.3. Cleaning of the camera
The camera shall NEVER be immersed in water or any other fluid. For cleaning, only use a light moist
tissue.
2.2.4. Maintenance
No specific maintenance other than cleaning is applicable.
2.2.5. Repair and modification
Repair, modification and replacement of parts shall be done only by Adimec to maintain compliance
with the directive 89/336/EEC electromagnetic compatibility and directive 72/23/EEC low voltage
directive and the international standards.
2.2.6. Peripheral equipment
For safety, use an external SELV qualified power supply. Maximum current 1 A.
For safety, peripheral equipment must either be double isolated or SELV qualified.
2.2.7. Mounting / Mechanical
Connectors
Take care during handling of the camera. The Camera Link connector and the power connector should
not be damaged.
The maximum tightening torque for the Camera Link connector may not exceed 0.26 Nm.
Prevent the entry of foreign objects or dirt into the connectors, as this will result in unreliable operation
or damage.
Mounting screws
Take notice of the maximum length of the screws that may be used for mounting of the camera. Using
screws too long can cause damage to the camera. Maximum screw length: 5 mm.
OPERATING AND USER MANUAL QUARTZ SERIES
11