Lightning Surge Protection; Outside Antenna; Signal Booster - Wilson Electronics 2B1401 Installation Manual

In-Vehicle/In-Building
Extension Cable Chart
The following Wilson extension cables are available to help you customize your installation
for peak performance .
5' Extension Cable RG58U
951101
Low Loss Coax
10' Extension Cable RG58U
951102
Low Loss Coax
15' Extension Cable RG58U
951103
Low Loss Coax
20' Extension Cable RG58U
951104
Low Loss Coax
20' Extension Cable Wilson 400
952320 (9913 Equivalent)
Ultra Low Loss Coax
30' Extension Cable Wilson 400
952330 (9913 Equivalent)
Ultra Low Loss Coax
50' Extension Cable Wilson 400
952350 (9913 Equivalent)
Ultra Low Loss Coax
Installing Lightning Protection
Install the Lightning Surge Protector (LSP) close
to the Signal Booster . Attach the cable from the
outside antenna to the surge protector . Using a
short length of low loss cable, attach one end to
the LSP and the other to the outside antenna .
Ensure the LSP is properly grounded. (For RG6
cable use #859988-75 Ohm, For 50 Ohm use Part
#859902) .
Contact Wilson Electronics Tech Support with any questions at 866-294-1660
Or email: tech@wilsonelectronics.com
75' Extension Wilson 400
952375 (9913 Equivalent)
Ultra Low Loss Coax
100' Extension Wilson 400
952400 (9913 Equivalent)
Ultra Low Loss Coax
2' Extension Wilson 400
(9913 Equivalent)
952302
Ultra Low Loss Coax
(N-Male to N-Male Ends)
2' Extension RG58U Low
951110 Loss Coax (N-Male to FME-
Female)
RG58U - FME connectors / 9913 - N connectors
From the
outside
antenna
Ground Wire
Lightning Surge
Protection
To the Signal Booster
Hours: 7am to 6pm MST.
6