Warnings And Recommendations - Wilson Electronics 2B1401 Installation Manual

Warnings and Recommendations

Warning: Verify that both the outside antenna and the adapter extension cable are
connected to the Signal Booster before powering up the Signal Booster .
RF Safety: In-Vehicle - The outside antenna must be installed with a
Warning:
separation of at least 20 inches from any of the vehicle's occupants or
nearby persons and must not be located or operating in conjunction
with any other antenna or Signal Booster . Use of a cellular Signal
Booster with an antenna gain higher than 6 .12 dBi is in violation of
FCC regulations, for which the offender is fully liable . All Wilson mobile
antennas are 6 .12 dBi or less .
RF Safety: In-Vehicle - All roof-mount antennas should be centrally
Warning:
located on the roof of the vehicle . Glass-mount antennas should be
located in the middle of either the front or back windshield . Mirror-mount
antennas should be at least 20 inches from any persons in or around the
vehicle .
Warning: RF Safety: In-Building - The outside antenna must be installed on an
outdoor structure with a separation of at least 26 inches from all persons
during normal operation . The outside building antenna must not have a
gain that exceeds 15 dBi . All Wilson outside building antennas have gains
of 15 dBi or less .
Warning: Do not plug in the power supply until the Outside Antenna and external
adapter cables are attached to the Signal Booster .
Lightning protection is recommended for all in-building installations .
NOTE: The aluminum casing of a Wilson Signal Booster will adjust very quickly to the
ambient temperature of its environment. For example, in the summer, when the inside
of a car can reach 140 degrees Fahrenheit, the Signal Booster temperature may be 150
degrees or higher. The casing will be hot to the touch, similar to a metal door handle or a
steering wheel. Such high temperatures will not damage the Signal Booster, nor do they
pose a fire risk to the vehicle. As recommended in these instructions, install the Signal
Booster in a location with adequate ventilation, such as under the seat, in the trunk or under
the dashboard. Keep the area free of items that could block air flow to the Signal Booster.
9
Contact Wilson Electronics Tech Support with any questions at 866-294-1660
Or email: tech@wilsonelectronics.com Hours: 7am to 6pm MST.