Table of Contents
Advertisement
! Never clean the same spot for longer than 10 seconds.
! Never direct the steam at people, animals, or items containing electrical
components (e.g. inside ovens, fridges, at switches and lights, microwave
ovens etc.).
! Never touch the bottom of the device during operation!
! While the device is in operation, the cleaning foot must not be held at a
slanted angle or be inverted as hot spray water may emerge!
! After use the floor cloth may still be very hot. If you wish to remove it, wait
about 5 minutes for it to cool down.
NOTE: Water residues in the filter or tank are due to this device having been tested.
When you first use the device or if you have not used it for a lengthy period of time,
you must hold the steam release button down for approx. 30 seconds after connecting
it to the mains to get the device ready for operation. During this time, you will hear a
pumping noise because the corresponding parts of the device need to fill up with water.
1. To ensure that the device can be put down easily , the joint in the cleaning foot (14)
latches in when the central piece is in the vertical position. To use the device, grab
hold of the top handle and tilt the handle to a position which is comfortable for
you, and if necessary place your foot on the cleaning foot as you do so.
2. Using your foot, press the On/Off switch (13) on the cleaning foot to switch on the
device.
3. Slide the cleaning foot forwards over the surface which is to be cleaned. The loose
dirt is taken up by the rotating brush and collected in the collecting container (15) of
the device.
4. Press the steam release button (1) to expel steam and clean the floor more
thoroughly.
5. If there are any more stubborn areas of dirt or you want to kill germs (e.g. in the
vicinity of toilets), hold the cleaning foot on one spot for a number of seconds (but
not longer than 10 seconds!).
6. If you want to replace or wash the floor cloth, let go of the steam release button,
switch off the device and pull the mains plug out of the plug socket. Wait for 5
minutes so that the device can cool down. Now you can change the floor cloth.
7. If steam stops being produced, the water tank is empty. Let go of the steam
release button, switch off the device and pull the mains plug out of the plug socket.
refill the tank in the manner described in the "Preparing the device/filling
water tank" section.
8. Once the cleaning procedure is complete and the device has completely cooled down,
please empty the water tank (see below).
7
Advertisement
Table of Contents
