Table of Contents
Advertisement
1. If not pre-fitted, attach one of the floor cloths supplied (8) to the bottom of the
cleaning foot using the Velcro fasteners.
2. If the water tank (4) is inserted in the device, remove the water tank by pulling it in
A vertical direction, up and away from the appliance, as show in the illustrations.
3. Unscrew the closure of the water tank, fill the water tank preferably with
distilled water at room temperature and then close it again. Firmly turn the closure
shut.
4. Place the water tank into the central piece (6) and press it down until it engages
audibly.
5. To quickly unwind the cable (10), turn the upper hook of the cable reel (11) so that
it points downwards. Then press the mains cable into the cable mount (2) so that
you are better able to handle the device while cleaning the floor and do not stumble
over the cable.
6. Now insert the plug into a suitable, easily accessible plug socket (120 V, 60 Hz).
The red control lamp (12) lights up as soon as the operating voltage is present.
7. To clean carpets, attach the carpet glider (7) with the flat side towards the floor and
place the cleaning foot into the carpet glider.
PLEASE NOTE! Only use the carpet glider on carpets and not on hard floors in order
To prevent damage to the floor!
B. Cleaning the floor
CAUTION:
! Keep children and animals away from the device during use.
! Make sure during use that dirt particles do not accumulate beneath the
cleaning foot as they could damage sensitive surfaces.
! Never operate the device with the steam function if the water tank is empty.
! During cleaning, make sure the floor cloth is firmly attached to the cleaning
foot to prevent damage to the device or flooring.
! Always first test the cleaning with steam on a small spot.
6
Advertisement
Table of Contents
