Table of Contents
Advertisement
B. Assembly
1. Place the central piece (6) onto the cleaning foot (14).
2. Screw the two parts together on the back using the screw which is also supplied.
3. Insert the water tank (4) into the central piece and press it down until it
engages audibly.
4. Slide handle assembly down into central piece (6) until it will go no further.
5. Screw the handle assembly and the central piece together by using the supplied long
Screw.
6. Turn the upper hook of the cable reel (11) so that it points upwards and wrap the
Mains cable (10) around the two hooks of the cable reel.
1
2
Use
This device sweeps up dust and loose dirt into the collecting container and then cleans
the floor with hot steam immediately after this. However, you can also activate the
sweep function and steam function individually.
We recommend that you first sweep a very dirty floor with the device and then clean it
with steam in a second step.
The water tank can be filled with tap water. However, in areas which have hard water,
we recommend that you use distilled water in order to prevent calcification.
A. Preparing the device/filling water tank
PLEASE NOTE!
! Never pour any cleaning agent or other additives into the water tank. These
may damage the device.
! Before using the device, always check the floor cloth for signs of wear. Do not
use it if it shows any signs of wear or if it is damaged! It could damage your
flooring!
3
4
5
5
Advertisement
Table of Contents
