Cmd": Command Response; Err": Error Message; Sta": Status Message - Radio Bridge RBM101i-319 User Manual

•

"CMD": Command Response

•

"ERR": Error Message

•

"STA": Status Message

•
"SEN": Sensor Payload
3.2.1. "CMD": Command Response
Response from a previous AT command. For example, for AT commands that set valid
parameters the host would expect the response:
CMD OK
If the AT command is requesting the firmware version which happens to be v1.01 the
response would be:
CMD 0101
3.2.2. "ERR": Error Message
This is an error message from the module that sends a 4-digit error code as ASCII coded hex
characters. For instance, error code 0x0000 would be represented by:
ERR 0000
See the Error Messages
3.2.3. "STA": Status Message
This is general status message from the module that sends a 4-digit status code as ASCII coded
hex characters. For instance, status message 0x0000 would be represented by:
STA 0000
C © 2017, R
OPYRIGHT ADIO
section for more detail.
Note that status messages do not include errors. For errors see the message
type Error Message. See the
B I .
RIDGE NC
R B
ADIO RIDGE
Status Messages section for more detail.
R B RBM101
ADIO RIDGE I
RBM101 U G
I SER UIDE
U G P 7
SER UIDE AGE OF
19