Table of Contents
Advertisement
4. M
ESSAGES
4.1. Sensor Event Messages
This section defines the sensor event messages that are sent from the module back to the
host over the serial port. The SEN message contains both Device Type and Sensor Status fields.
Each Device Type listed below has a corresponding table that defines the Sensor Status bits.
Note that these tables have been established for third-party manufacturers and thus are not
complete in terms of all combinations of sensor codes. However, the primary functions of a
sensor such as open/close, tamper on/off, etc. are provided here to give the user basic
functionality. It is highly recommended to test all boundary conditions for each sensor to be
used in an end application and verify the tables for that use case.
In the tables below, an "x" denotes a "don't care" condition for the associated bits. See the
RBM101i-319 product page on the Radio Bridge website for updated tables.
Status Bits
xx11xxxxxxxx
xx10xxxxxxxx
xx00xxxxxxxx
xxxxxx11xxxx
xxxxxx10xxxx
xxxxxx00xxxx
C
© 2017, R
OPYRIGHT
ADIO
Table 10 Status Bits Description
Description
Sensor opened
Sensor is still open after it has been previously reported. Usually
these bits are set when another event occurs and device is still in
open state.
Sensor closed
Tamper event true
Tamer is still true after it has been previously reported. Usually
these bits are set when another event occurs and device is still in
tamper state.
Tamper event false
B
I
.
RIDGE
NC
R
B
ADIO
RIDGE
R
B
RBM101
U
ADIO
RIDGE
I
RBM101
U
G
I
SER
UIDE
G
P
13
19
SER
UIDE
AGE
OF
Advertisement
Table of Contents
