Network; Encoder - Bosch DINION IP 5000 MP Software Manual

Camera Browser
Interface
4.3

Network

The settings on these pages are used to integrate the device
into a network. Some changes only take effect after a reboot. In
this case Set changes to Set and Reboot.
1.
2.
The device is rebooted and the changed settings are activated.
If the network has a DHCP server for the dynamic assignment of
IP addresses, select On to automatically accept the DHCP-
assigned IP address.
For certain applications, the DHCP server must support the
fixed assignment between IP address and MAC address, and
must be appropriately set up so that, once an IP address is
assigned, it is retained each time the system is rebooted.
IP address
Enter the desired IP address for the camera. The IP address
must be valid for the network.
Subnet mask
Enter the appropriate subnet mask for the set IP address.
Gateway address
For the device to establish a connection to a remote location in
a different subnet, enter the IP address of the gateway here.
Otherwise, this field can remain empty (0.0.0.0).
4.4

Encoder

Select a profile for encoding the video signal on stream 1 (this is
not a selection of the recording profile).
Pre-programmed profiles are available that give priority to
different parameters and they should be selected based on your
operating environment.
When a profile is selected, its details are displayed.
Bosch Security Systems
Make the desired changes.
Click Set and Reboot.
Basic Mode | en
2015.04 | v1.592 | AM18-Q0678
25