Table of Contents
Advertisement
4
ESC Setup
Lipo Battery Mode
If the power is cutting off and on (pulsing) while driving, the LiPo battery cutoff has been activated in the speed control. Stop driving the car im-
mediately and recharge or replace the battery.
Choose Battery Mode
The ESC is programmed with the use of jumpers to select setting. (Tweezers are recommended to plug in the jumpers)
Jumper
Low voltage cut-off protection
If the voltage of the battery pack is lower than the threshold for 2 seconds, the ESC will enter the protection mode.
When the car stops, the red LED blanks on the ESC to indicate that the low voltage cut-off protection has been activated.
Mode batterie LiPo
Choisissez le mode de la batterie
Reverse
Battery type
5-9 элементов
Output reduces to 50% at 4.5V. ESC cuts off at 4.0V when battery cannot supply enough voltage.
NiMH
L
2S LiPo
Output reduces to 50% at 6.5V. ESC cuts off at 6.0V when battery cannot supply enough voltage.
3S LiPo
Output reduces to 50% at 9.75V. ESC cuts off at 9.0V when battery cannot supply enough voltage.
There are two battery modes to choose from (NiMH or LiPo).
Factory setting is set to NiMH mode.
LiPo
10
NiMH
Hide quick links:
Advertisement
Table of Contents
