HPI Racing JUMPSHOT MT Instruction Manual page 32

Binding and Fail Safe
you must re-bind before operating your vehicle.
Caution
1
Bring the transmitter and the receiver close to each other, within 0.5 meter.
2
1
ON
3
Fail Safe Setup
Leave throttle trigger in neutral position, and press the setup
Once the receiver LED remains lit, then release the setup button on the receiver.
1 1
Stop (Neutral)
Fail-Safe
c transmitter. Binding is pre-set from the factory. If you change transmitters or add a receiver,
If you change transmitters or add a receiver, you must re-bind before operating your vehicle.
20" / 50cm MAX
(20")
2
ON
LED continuously lit.
Remove body and tires before starting installation.
OPEN
2 3
After 1 Seconds
34
Use a thin object such as a paperclip
LED light turns off.