Installing Your Appliance; Cabinet Clearance; Leveling Legs; Select Location - AGA marvel ML15CL Installation, Operation And Maintenance Instructions

CAUTION
!
If the appliance was shipped, handled, or stored in other
than an upright position for any period of time, allow the ap-
pliance to sit upright for a period of at least 24 hours before
plugging in. This will assure oil returns to the compressor.
Plugging the appliance in immediately may cause damage
to internal parts.
WARNING
!
WARNING - Help Prevent Tragedies
Child entrapment and suffocation are not problems of
the past. Junked or abandoned refrigerators are still
dangerous - even if they sit out for "just a few hours".
If you are getting rid of your old refrigerator, please
follow the instructions below to help prevent acci-
dents.
Before you throw away your old refrigerator or
freezer:
• Take off the doors or remove the drawers.
• Leave the shelves in place so children may not
easily climb inside.

Select Location

The proper location will ensure peak performance of your
appliance. We recommend a location where the ice ma-
chine will be out of direct sunlight and away from heat
sources. To ensure your product performs to specifications,
the recommended installation location temperature range
is from 55 to 90°F (13 to 32°C) for built in ice machines and
55 to 100°F (13 to 38°C) for freestanding ice machines. Ice
machines will not perform correctly in ambient tempera-
tures less than 55°F (13°C).

INSTALLING YOUR APPLIANCE

Cabinet Clearance

Ventilation is required from the bottom front of the appli-
ance. Keep this area open and clear of any obstructions.
Adjacent cabinets and counter top can be installed around
the appliance as long as the front grille remains unob-
structed. Overlay door models with articulated hinges are
intended for built-in applications only.
Front Grille
Do not obstruct the front grille. The openings within the
front grille allow air to flow through the condenser heat ex-
changer. Restrictions to this air flow will result in increased
energy usage, loss of cooling capacity and low ice produc-
tion. For this reason it is important this area not be obstruct-
ed and the grille openings kept clean. AGA MARVEL does
not recommend the use of a custom made grille as air flow
may be restricted. (See Figure 2).

Leveling Legs

Adjustable legs at the front and rear corners of the appli-
ance should be set so the unit is firmly positioned on the
floor and level from side to side and front to back. The
overall height of your Marvel appliance may be adjusted
higher (by turning the leveling leg out) and lower (by turning
the leveling leg in). Cabinet height adjustment dimensions
are shown in Table "A".
To adjust the leveling legs, place the appliance on a solid
surface and protect the floor beneath the legs to avoid
scratching the floor. With the assistance of another person,
lean the appliance back to access the front leveling legs.
Raise or lower the legs to the required dimension by turning
the legs. Repeat this process for the rear by tilting the appli-
ance forward using caution. On a level surface check the
appliance for levelness and adjust accordingly.
The front grille screws may be loosened to raise and lower
the grille to the desired height. When adjustment is com-
plete tighten the two front grille screws. (See Figure 5).
4
CAUTION
!
Front Leveling
Legs
Figure 2
Front Grille,
keep this area
open.
Rear
Leveling
Legs