Sony Trinitron KV-B14PD1 Operating Instructions Manual page 6

Presetting channels
You can preset up to 100 TV channels in numerical
sequence from program position 1 automatically.
To change the channel for a particular program
position or to receive a channel with a weak signal,
you can preset the channel manually. You can also
disable program position.
You can preset TV channels using the buttons on the
TV or the remote commander.
Presetting channels automatically
using the buttons on the TV
2 1
Front of TV
POWER
R
COLOR SYSTEM SELECT TV SYSTEM MANUAL PROGR AUTO PROGR
1
Press POWER to turn on the TV.
POWER
When the TV is turned on in standby mode, press
POWER on the remote commander.
2
Press AUTO PROGR.
1 2 3
AUTO PROGR
To start presetting channels automatically
from the specified program position
1 Press MANUAL PROGR.
2 Press PROGR +/– to select the program position.
3
Press AUTO PROGR.
6
Getting Started
Presetting channels manually using the
buttons on the TV
1
Press MANUAL PROGR.
2
Press PROGR +/– on the remote commander
until the required program position
appears on the screen.
3
Press VOLUME +/– until the required channel
picture appears on the screen.
4
Press MANUAL PROGR.
Disabling program positions using the
buttons on the TV
By disabling unused or unwanted program positions,
you can skip those positions when you press
PROGR +/– on the remote commander.
1
Press PROGR +/– on the remote commander
until the unused or unwanted program
position appears on the screen.
2
Press MANUAL PROGR.
3
Press PIC MODE on the remote commander.
4
Press MANUAL PROGR.
To cancel the skip setting
Preset the channel manually or automatically again.
1
Presetting channels automatically
using the remote commander
+ or –
SELECT
1
Press POWER to turn on the TV.
POWER
When the TV is turned on in standby mode, press
POWER on the remote commander.
2
Press SELECT until "AUTO PROGRAM"
appears.
SELECT
AUTO PROGRAM
3
Press + or – .
VHF LOW B/G
4
Press + or – .
1 2 3 1
Presetting channels manually using the
remote commander
1
Press PROGR +/– or a number button until
the required program appears on the
screen.
PROGR
1 2 3
4 5 6
or
7 8 9
÷
0
JUMP
2
Press SELECT until "MANUAL PROGRAM"
appears.
SELECT
MANUAL PROGRAM
3
Press + or – .
VHF LOW B/G
4
Press + or – .
1
The selected channel appears on the screen.
5
Press SELECT to return to normal screen.
SELECT
If you are not satisfied with the picture
and sound quality
You may be able to further improve the picture and
sound quality by using fine tuning as below:
1
Select the program position you want to
adjust.
2
Press SELECT until "MANUAL PROGRAM"
appears on the screen.
3
Press + or – on the remote commander
once.
4
Press DISP until "FINE" appears on the
screen.
5
Press + or – continuously until you are
satisfied with the picture and sound
quality.
6
Press SELECT to return to normal screen.
7
Getting Started