Orion OLS-32 User Manual page 17

OLS-32/40/46/55/70/8201TGB/P
4. Connect & Disconnect
- You can connect RS232 input and control PC using RS232 Cable.
- Select the Port you can connect to your PC (refer to ② in the image above) and press connect button.
If connected properly, the lamp will be turned to BLUE (from RED). If not connected properly, the following
message will appear.
Unable to open serial port : The port may not be available in your PC or another program may be running
under this port.
Cannot connect with Easy DiD System : RS232 Cable may not be connected properly or Set ID may be
incorrect. Re-check on Set ID.
5. DID Set Control
1) Basic Control
2) Virtual Remocon
- Select Control Tab
Power Control : Turn the Set On/Off
Source Control : Select Source
Sound Mute : Turn the Mute On/Off
PC Auto Adjust :
- Select Remocon Tab
- This virtual remote controller controls the set
through RS232.
17
페이지
17 of 36
3/30/2012