Panasonic DMP-BD45GA Service Manual page 10

Error Code Diagnosis contents
F58 Drive hardware error
F74 HDMI Device Key Communica-
tion error.
F75 HDMI incompatible
(HDMI incompatible)
F99 Hang-up
UNSUP- Unsupported disc error
PORT
NO READ Disc read error
HARD Drive error
ERR
SELF Restoration operation
CHECK
UNFOR- Unformatted disc error
MAT
PLEASE Unit is in termination process
WAIT
No PLAY When there is a viewing restric-
tion on a BD-Video or
DVD-Video.
4.1.2. Special Modes Setting
Mode name
Rating password The audiovisual level setting password is
initialized to Level 8.
Description
When drive unit error is detected, the event is
saved in memory.
This error is displayed when the information
error is occurred at HDMI device key loading.
error Display this error when the equipment (com-
patible with DVI such as TV, amplifier etc.)
connected to the unit by HDMI is incompatible
with HDCP (High-bandwidth Digital Content
Protection).
Displayed when communication error has
occurred between Main microprocessor and
Timer microprocessor.
*An unsupported format disc was played,
although the drive starts normally.
*The data format is not supported, although
the media type is supported.
*Exceptionally in case of the disc is dirty.
*A disc is flawed or dirty.
*A poor quality failed to start.
*The track information could not be read.
The drive detected a hard error.
Since the power cord fell out during a power
failure or operation, it is under restoration
operation.
*It will OK, if a display disappears automati-
cally. If a display does not disappear, there is
the possibility that defective Digital P.C.B. /
BDP drive.
This error is displayed when the unformatted
DVD-RAM/DVD-RW or the DVD-RW
recorded by another make of recorder is
inserted.
Unit is in termination process now.
"BYE" is displayed and power will be turned
off.
Rating password is set.
Item
Description
Monitor Display
No display
No display
No display
No display
"This disc
incompatible."
"Cannot
Please check the
disc."
"DVD drive error."
No display
No display
No display
No display
FL display
10
Automatic FL display
No display
Displayed is left until the [POWER]
key is pressed.
is
It is displayed for 5 seconds.
The character indication flows
sideways.
read.
It is display for 5 seconds.
The character indication flows
sideways.
The character indication flows
sideways.
UNFORMAT
This disc is not formatted properly.
Format the disc in DISC MAN-
AGEMENT?
The character indication flows
sideways.
Key operation
Front Key
While the unit is on, press and
hold [OK], [B] and [Y] on the remote
control at the same time for more
than 5 seconds.
- "00 RET" is displayed on the unit's
display.
[
Repeatedly press
remote control or [POWER] on the
unit until "03 VL" is displayed on the
unit's display.
Press [OK] on the remote control
or [OPEN/CLOSE] on the unit.
]
on the