Broadview BVNDESK10 Setting-Up Manual page 5

SeT Up The phOne
3
Connect the power adapter to the phone and plug it into
a wall outlet, no more than 150 feet from the base station .
Connect the short end of the phone cord to the bottom of
the handset and the long end into the port on the back of
the desk phone .
4
InSTallIng The phOne STand
There are two options for attaching the stand to the phone:
To have your phone display in a more upright
position: Insert the connector tab on the stand with the
square cutouts into the large opening on the top of the
back of the phone, be sure it locks in place .
To have your phone display at a lower angled
position: Insert the connector tab on the stand with the
square cutouts directly underneath the large opening on
the back of the phone, be sure it locks in place .
SySTeM UpdaTeS
From time to time, Broadview Networks will make updates to your system via software changes on our network . To ensure
your system is up-to-date with the most current release of software, momentarily disconnect power from the base station
(leave the Ethernet cable connected) and then reapply power . If new software is available, the base station will download it
from Broadview's servers and install it on the base station and the phones . During the software upgrade process, the base
station LED will blink amber and then blink blue
then Rebooting System .
DO NOT ReMOVe POweR DuRINg The PROceSS.
minutes and the phone display has returned to normal before making any calls . You may repeat this process occasionally to
be sure your software is always up-to-date .
8 Connecting Your Desk Phone and Base Station
5
Momentarily disconnect power from the base station (leave
the Ethernet cable connected) and then reapply power . The
base station will automatically download and install new
software if a newer version is available . If newer software is
downloading the LED will flash blue . This process takes 3 to 4
minutes and it is important that you do NOT remove power
again while software is updated . Wait until the LED is steady
amber (not blinking) for two minutes before making calls .
6
Follow the instructions on the next few pages for Setting up
Your Systems and Features through the MyOfficeSuite™
portal .
for several minutes . The display on the phones will read Provisioning and
Wait until the LED on the base station glows steady
1A
Desk Phone
(Back)
amber for a few
Wall Outlet
Connector Tab
2
OR
Stand
1B
Desk Phone (front)
Connecting Your Desk Phone and Base Station
Page Key
3
Base Station
(included)
leD light
9