Samsung HPS5033X/XAC Service Manual page 110

11-3-5 How to Adjust Mounting Angle
Note : Please secure the mounting bracket on the wall surface after setting its angle at 0°
Note
1. Secure the SET to the wall mount bracket.
(Please refer to the following instructions.)
2. Set the angle by pulling the upper end of the SET
attached to bracket in the direction of the arrow.
(Refer to the illustration on the right.)
3. The angle can be adjusted from 0° to 15° by ±2°.
11-3-6 Connecting External Devices to the PDP
Note : To connect external devices such as a DVD or a Home Theater System to the PDP,
Note
please refer to following instructions:
Samsung Electronics
Hold onto the middle of the PDP
to adjust the angle (not the sides
of the PDP).
1. Be sure to remove the safety pins underneath
the PDP.
Note : If the safety pins are not removed,
Note
the angle cannot be adjusted.
Any attempt to do so may cause
damage to the PDP.
2. Hold onto the bottom of the PDP and pull
forward fully as directed by the arrow as
illustrated) to adjust the angle. (0°~20°by 2°)
Insert the Safety Pins to the front guide holes on
both sides as illustrated in figure
Note : Viewing the PDP after connecting the
Note
external devices Remove the Safety
Pins to adjust the angle to 0 ° , and
then secure the Safety Pins again.
• For safety, be sure to secure the PDP using
the safety pins. If the safety pins are not
used, the PDP may fall, causing serious injury.
Operation Instruction & Installation
.
11-9