Troubleshooting - Philips AZ1080 User Manual

AZ1080/01 03/07/02 11:31
If a fault occurs, first check the points listed below before taking the set for repair. Do
not open the set as there is a risk of electric shock.
If you are unable to remedy a problem by following these hints, consult your dealer or
service centre.
WARNING: Under no circumstances should you try to repair the set yourself, as this
will invalidate the guarantee.
Problem
No sound
No power
Display does not function
properly/ No reaction to
operation of any of the
controls
Er indication
CD playback does not work
The CD skips tracks
Poor cassette sound quality
Recording does not work
Page 13
Solution
– Adjust the VOLUME
– Mains lead not securely connected.
Connect AC mains lead properly
– Batteries exhausted /incorrectly inserted.
Insert (fresh) batteries correctly
– Electrostatic discharge
Switch off and unplug the set. Reconnect after a few
seconds.
– No CD inserted, insert a CD
– CD badly scratched/ dirty.
Replace/ clean CD (see maintenance)
– CD-R(W) is blank or the disc is not finalized.
Use a finalized CD-R(W)
– Laser lens steamed up.
Wait until lens has cleared/acclimatized
– CD badly scratched/ dirty. Replace/ clean CD (see
maintenance)
– CD damaged or dirty. Replace or clean CD.
– Shuffle is active. Quit shuffle mode
– Dust and dirt on the heads, etc.
Clean deck parts, see maintenance.
– Use of incompatible cassette types (METAL or
CHROME). Only use NORMAL (IEC I) for recording
– Cassette tab(s) may be broken. Apply a piece of
adhesive tape over the missing tab space.

Troubleshooting

13