Sony HCD-CP505 Service Manual page 7

Note 1: About "R"
As this unit has only a few buttons, some operations require the use of remote commander (RM-SCP500/provided with unit) buttons. These
operations are indicated as "R" in this manual.
Example: MENU/NO "R" ...Press the MENU/NO button of the remote commander.
Note 2: Incorrect operations may be performed if the test mode is not entered properly.
In this case, press the
How to Operate the Self-diagnostics Function (Error History Display Mode)
Note: Use the self-diagnostics function in the "error history display mode" of the test mode. The least required procedure is described
below. Do not enter any other modes by mistake. If you have entered any other modes accidentally, press the MENU/NO "R"
button to exit the mode.
1. Press the ?/1 button to turn on the power.
2. Press the FUNCTION button to select the "MD" function.
While pressing the x button and the ENTER/START button at the same time, press the FUNCTION button.
3.
4. Press the > "R" button to display "[Service]". Then press the ENTER/YES "R" button.
5. Press the "R" button to display "Err Display".
>
6. Press the ENTER/YES "R" button to enter the error history display mode and "op rec tm" appears.
7. Select the desired contents that you want to display or to execute using the
8. Press the REC MODE button to display or to execute the selected contents.
9. Press the REC MODE button again to return to step 7.
10. Press the MENU/NO "R" button. The message "Err Display" appears and you exit the error history mode.
11. Press the REPEAT button twice to exit the test mode.
12. Press the button to turn off the power.
?/1
? button to turn the power off, and retry to enter the test mode.
/1
"R" button or the "R" button.
. >
HCD-CP505
7