Using The Air Conditioner - Insignia NS-AC14PWH8 User Manual

Using the air conditioner

You can control your air conditioner by using the control panel on the
front of the unit, or by using the remote control. If using the remote
control, always point it at the air conditioner.
Button Description
Press to turn your air conditioner on or off.
When you turn the air conditioner on, you will hear a tone and the air discharge automatically opens. The
display shows the set temperature and the current mode.
POWER
When you turn your air conditioner off, you will hear a tone and the air discharge closes. Control settings, such
as Mode, Set Temperature, Auto Swing, and so on, are retained in memory when the power is off (unless the
unit has been unplugged).
Press to cycle through the operating modes (COOL, FAN, DRY, or ENERGY SAVER). The LED display shows the
active mode. The default mode is COOL.
COOL–The compressor runs and cools the room. Use the
MODE
temperature and fan speed.
FAN–The fan circulates the air, but the compressor does not run to cool it. Use the
fan speed.
DRY–The fan and dehumidifier both run to remove humidity from the air. After the set temperature is reached,
the compressor and fan turn off. The fan speed is preset and cannot be adjusted.
ENERGY SAVER– If the ambient temperature is above 77° F (25°C), the air conditioner operates in cooling
mode. If the ambient temperature is below 77° F (25°C), the air conditioner operates in fan mode.
Cycles through the available fan speeds (F1-Low, F2-Medium, F3-High). The LED next to the
displays the fan speed. The speed can be selected in either the COOL or FAN modes.
FAN
COOL and DRY modes–press to adjust the temperature setting up to 86°F (30°C) or down to 62°F (17°C), in one
degree increments. The temperature can be switched between Fahrenheit and Celsius by pressing
at the same time, or by pressing the °F--°C button on the remote control.
  TIMER mode–press
press and hold
NOTE: The temperature displayed is the room temperature, not the set temperature. In COOL, DRY, or ENERGY
SAVER mode, the thermostat in the air conditioner runs the compressor until the set temperature is reached,
then the compressor cycles on and off to maintain the set temperature.
Press to set your air conditioner to turn off or turn on after a delay of up to 24 hours. The default is 0.
\
Automatic off–press
in one hour increments. The air conditioner automatically turns off when the set delay time is reached.
TIMER
Automatic on–press
one hour increments. The air conditioner automatically turns on when the set delay time is reached.
Press the TIMER button to see the delay time you have set on the LED display.
To change the set delay time (on or off), press the TIMER button, then adjust the time with the
buttons when the number begins to blink.
To cancel the Timer function, press the TIMER button, then press the
begins to blink to adjust the time to 0. You can also press the TIMER button, then press it again when the
number begins to blink.
NOTE: Do not unplug the air conditioner while using the Timer function. After setting the Timer function, if
you use the remote control to change to another mode without resetting the Timer function, the timer is reset.
 
or to adjust the delay time from one to 24 hours, in one hour increments. If you
 
or , the set temperature or time changes automatically.
 
or while the air conditioner is running to set the delay time from one to 24 hours,
 
or while the air conditioner is off to set the delay time from one to 24 hours, in
www.insigniaproducts.com
14,000 BTU Portable Air Conditioner
 
or and buttons to set the desired
 
or buttons when the number
button to set the desired
button
 
and
 
or
21