Basic Functions/General Information - Philips AZ 1564 User Manual

BASIC FUNCTIONS
SWITCHING ON AND OFF
• Adjust the POWER slider to the desired sound source: CD,
TUNER or TAPE.
• The set is switched off when the POWER slider is in the
TAPE/OFF position and the buttons on the tape deck are
released.
– The volume, sound settings and tuner presets will be retained in
the set's memory.
ADJUSTING VOLUME AND SOUND
1. Turn the VOLUME control clockwise to increase or
anti-clockwise to decrease volume on the set (or press VOLUME
3 or 4 on the remote control).
™ Display shows the volume level indication: on the volume bar,
, and a number from 0-32.
VOL
2. Press DIGITAL DBB to switch dynamic bass boost on or off.
™ If on, the DIGITAL DBB light goes on.
3. Press INCREDIBLE SURROUND to switch the surround sound
effect on or off.
™ If on, the INCREDIBLE SURROUND light goes on.
Note: The effect of INCREDIBLE SURROUND may vary with
different types of music.
GENERAL INFORMATION
General maintenance
• Do not expose the set, batteries, CDs or cassettes to humidity,
rain, sand or excessive heat caused by heating equipment or
direct sunlight.
• To clean the set, use a soft, slightly dampened chamois leather.
Do not use any cleaning agents containing alcohol, ammonia,
benzene or abrasives as these may harm the housing.
Safety information
• Place the set on a hard and flat surface so that the system does
not tilt. Make sure there is adequate ventilation to prevent the
system from overheating.
• The mechanical parts of the set contain self-lubricating bearings
and must not be oiled or lubricated.
10
GENERAL INFORMATION