Basic Functions; General Information; Safety Information - Philips AZ1065 User Manual

BASIC FUNCTIONS

Switching on and off
1. Adjust the POWER slider to the desired sound source: CD,
TUNER or TAPE/
OFF
™ The respective function indicator:
2. To switch off, adjust the POWER slider to TAPE/
with the keys on the tape deck released.
™ The respective function indicator:
™ The volume and tuner presets will be retained in the set's
memory.
Adjusting volume and sound
1. On the set press the VOLUME control to increase or decrease
+
volume (or press or
™ Display shows the volume level VOL and a number from 0-32.
2. Adjust the DBB control to select dynamic bass boost on or off.
PHILIPS demo mode
1. On the set or remote control, press the CD STOP 9 button for
5 seconds.
™ After about 30 seconds, PH..IL ..IPS scrolls across the display.
2. To return to the current display you can either:
• press any function button on the front panel. This interrupts
the demo mode for 30 seconds;
• press the CD STOP 9 button for 5 seconds. PH..IL ..IPS
scrolls once before the demo mode is cancelled.

GENERAL INFORMATION

General maintenance
• Do not expose the set, batteries, CDs or cassettes to humidity,
rain, sand or excessive heat caused by heating equipment or
direct sunlight.
• To clean the set, use a soft, slightly dampened chamois
leather. Do not use any cleaning agents containing alcohol,
ammonia, benzene or abrasives as these may harm the
housing.

Safety information

• Place the set on a hard and flat surface so that the system
does not tilt. Make sure there is adequate ventilation to
prevent the system from overheating.
• The mechanical parts of the set contain self-lubricating
bearings and must not be oiled or lubricated.
10
.
,
CD TUNER
,
CD TUNER
–
on the remote control).
GENERAL INFORMATION
or lights up.
TAPE
position
OFF
or goes out.
TAPE