Troubleshooting; Technical Specifications Pro-Ject Stereo Box S2; Service; Warranty - Box-Design Pro-Ject Stereo Box S2 Instructions For Use

Troubleshooting

No music from my speakers:
- make sure power cables, audio interconnects and speakers are correctly connected to Stereo Box S2
- make sure volume level is properly set
- make sure the correct input is selected

Technical specifications Pro-Ject Stereo Box S2

Power output:
Frequency response:
Channel separation:
Noise floor:
THD:
Gain:
Line-level inputs:
Input sensitivity:
Input impedance:
Record Out:
Speaker connectors:
Outboard power supply: 20V/3A DC, suitable for your country's mains supply
Power consumption:
Replacement battery remote control: 1 x CR2032 / 3V or 1 x CR2025 / 3V
Dimensions W x H x D (D with sockets): 103 x 37 x 129 (138)mm
Weight:

Service

Should you encounter a problem which you are not able to alleviate or identify despite the above information,
please contact your dealer for further advice. Only if the problem cannot be resolved there, the unit should
be sent to the responsible distributor in your country.

Warranty

The manufacturer accepts no responsibility for damage caused by not adhering to these instructions
for use. Modification or changes to any part of the product by unauthorized persons release the
manufacturer from any liability over and above the lawful rights of the customer.

Copyright, trademarks

Pro-Ject Audio Systems is a registered Trademark of
H. Lichtenegger.
This guide was produced by: Pro-Ject Audio Systems
Copyright © 2017. All rights reserved.
4
© Pro-Ject Audio Systems · Pro-Ject Stereo Box S2 · Revision 2017.6.21
2 x 25W/37W at 8 ohms/4 ohms (both channels driven)
5Hz - 20kHz (+0dB, -0,5dB)
>65dB at 20kHz
>90dB (A weighted)
<0,1% at 18W
32dB
2 pair RCA/phono sockets, 1x jack socket 3.5mm
350mV
50kohms
3-pole 3,5mm co-axial jack
4mm ∅ banana plugs, spades connectors or naked wire
3A DC, <1W in standby
660g without power supply
The information was correct at the time of going to
press. The manufacturer reserves the right to make
changes to the technical specification without prior
notice as deemed necessary to uphold the ongoing
process of technical development.