Hyundai Azera 2005 Owner's Manual page 263

G290B01TG-GAT
Adjustment After Headlight As-
sembly Replacement
Left-Hand Drive (Low Beam)
Vertical
Horizontal line
line
30 mm
W
"P"
H
Cut-off line
Ground line
L
H
G290B01TG
Left-Hand Drive (High Beam)
Vertical
Horizontal line
line
30 mm
45 mm
H
90 mm
L Ground line
H
G290B02TG
Right-Hand Drive (Low Beam)
Vertical
Horizontal line
line
W
"P"
30 mm
H
Cut-off line
H Ground line
L
G290B01TG-R
If the vehicle has had front body repair
and the headlight assembly has been
replaced, the headlight aiming should
be checked using the aiming screen
as shown in the illustration. Turn on
the headlight switch (Low Beam Posi-
tion or High Beam Position).
1. Adjust headlights so that main axis
of light is parallel to the center line
of the body and is aligned with
point "P" shown in the illustration.
2. Dotted lines in the illustration show
the center of the headlights.
DO-IT-YOURSELF MAINTENANCE
SPECIFICATION:
"H"
Horizontal center line of headlights
from ground;
Low Beam : 691 mm (27.2 in.)
High Beam : 680 mm (26.77 in.)
"W"
Distance between each headlight cen-
ter;
Low Beam : 1,350 mm (53.14 in.)
High Beam : 1,080 mm (42.51 in.)
"L"
Distance between the headlights and
the wall that the lights are tested
against: 3,000 mm (118.11 in.)
6
27