AEG HK654850XB User Manual page 16

16 www.aeg.com
Problem
You cannot activate the out-
er ring.
There is a dark area on
the multiple zone.
The heat setting changes
between two levels.
The sensor fields become
hot.
There is no signal when you
touch the panel sensor
fields.
comes on.
comes on.
and a number come on.
E6 comes on.
8.2 If you cannot find a
solution...
If you cannot find a solution to the
problem yourself, contact your dealer or
an Authorised Service Centre. Give the
data from the rating plate. Give also
three digit letter code for the glass
ceramic (it is in the corner of the glass
Possible cause
It is normal that there is a
dark area on the multiple
zone.
Power management function
operates.
The cookware is too large or
you put it too near to the
controls.
The signals are deactivated.
Automatic Switch Off oper-
ates.
The Child Safety Device or
the Lock function operates.
There is an error in the hob.
The second phase of the
power supply is missing.
surface) and an error message that
comes on. Make sure, you operated the
hob correctly. If not the servicing by a
service technician or dealer will not be
free of charge, also during the warranty
period. The instructions about the
Service Centre and conditions of
guarantee are in the guarantee booklet.
Remedy
Activate the inner ring first.
Refer to "Daily use" chapter.
Put large cookware on the
rear zones if possible.
Activate the signals.
Refer to "Daily use" chapter.
Deactivate the hob and acti-
vate it again.
Refer to "Daily use" chapter.
Disconnect the hob from the
electrical supply for some
time. Disconnect the fuse
from the electrical system of
the house. Connect it again.
If comes on again, speak
to an Authorised Service
Centre.
Check if the hob is correctly
connected to the electrical
supply. Remove the fuse,
wait one minute, and insert
the fuse again.