Table of Contents
Advertisement
where you purchased this unit, or the car
dealer, before installation.
Note
Before attaching the double-sided tape , clean
the surface of the dashboard with a dry cloth.
Using the wired remote control
When using the steering wheel remote
control
Installation of the connection cable RC-SR1
(not supplied) is required before use.
1
To enable the steering wheel remote
control, select [SET STEERING] [EDIT
CUSTOM] to make the registration (page 22).
When the registration completes, the
steering wheel remote control becomes
available.
Notes on installing the connection cable
RC-SR1 (not supplied)
• Refer to the support sites on the back cover for
details, then connect each lead properly to the
appropriate leads. Making an improper
connection may damage the unit.
• Depending on the type of car, be sure to insulate
the unused leads with electrical tape for safety.
• Do not connect this cable when the steering wheel
remote control is not used.
• Consulting the dealer or an experienced
technician for help is recommended.
When using the wired remote control
1
To enable the wired remote control, set [STR
CONTROL] in [SET STEERING] to [PRESET]
(page 22).
Installation
Removing the protection collar
and the bracket
Before installing the unit, remove the
protection collar and the bracket from
the unit.
1
Pinch both edges of the protection
collar , then pull it out.
2
Insert both release keys until they
click, and pull down the bracket ,
then pull up the unit to separate.
Face the hook inwards.
Mounting the unit in the
dashboard
• Before installing, make sure the catches on
both sides of the bracket are bent
3
inwards 2 mm (
/
32
• For Japanese cars, see "Mounting the unit
in a Japanese car" (page 42).
1
Position the bracket inside the
dashboard, then bend the claws
outward for a tight fit.
53 mm (2
2
Mount the unit onto the bracket ,
then attach the protection collar .
in).
182 mm (7
/
1
4
1
/
in)
8
Catch
41
in)
GB
Hide quick links:
Advertisement
Table of Contents
