Networking - Raw Thrills Super Bikes Operator's Manual

Game Networking
NOTICE: To link the two games together, use the crossover cable provided in the spare parts bag. Use of
another cable other than the one shipped with the game could void warranty or cause games not to link. Use
network cables, which are at least CAT5 grade.
Networking Considerations
Each FNFSB game ships with a cross over cable for linking 2 games. Optionally, a hub and network patch cords
can be installed to link 3 or more games.
Take care to protect exposed game wiring from general foot traffic around the game. Use a conduit or wire way to
protect the cables as needed.
Please mark linking cables for your game if other such cables are in the vicinity to avoid confusion. Network
cables are not marked or coded.
Avoid routing the network cables near sources of heat, moisture or electrical energy such as neon lights,
compressor motors, transformers etc.
Networking Setup 2 Games
1. Remove the cross over network cable from the parts bag located inside the cashbox.
2. If you are linking two games connect each end of the cable to the network jack behind each PC.
(Back of computer)
CONNECT NETWORK CABLE HERE
3. Neatly route the cable through the notch on the back of the cabinet.
4. Use the Dipswitch diagram below for enabling link feature and master/slave configuration. The Dipswitch
is located on the JAMMA I/O board. The JAMMA I/O board is mounted inside the back of the cabinet.
5. Reset all games simultaneously and verify that link is successful. If not, check the Dipswitch settings and
make sure that the network cable is connected properly and secured. Please refer to the troubleshooting
guide in this manual for more details.
DIP SWITCH DIAGRAM:
DIP SW#
Player1 / MASTER
Player 2
The Fast and the Furious Super Bikes • Copyright 2006 • Raw Thrills Inc • All rights reserved
SW1 SW2 SW3
OFF OFF OFF
ON OFF OFF
SW4 SW5 SW6
April 26, 2006
SW7 SW8
* ON
* ON
.
9