Preston Ability BREEZE-C Maintenance Manual page 10

7.1 Controller Parameter List and programming with hand
programmer SP1 :
BREEZE C
PROGRAMER SET-UP .
Programming version list : 8.0.16. 22/07/10
The list of parameters fit to power-units 950W-12km/h,10km/h and 15km/h.
The parameters refer to "S-Drive 120" controller with hand programmer "SP1"
To program through the "Charge Socket" use the adaptor.
Programmer SP1
Instructions to change the parameters :
1. Connect the adaptor to the programmer and connect to the "Charge Socket" –
the programmer will start working.
2. The up / down arrows let you choose the parameters.
3. In order to change a parameter – stand on the parameter press "enter" the
values will then appear in the display window.
4. With the help of the arrows you can change the values.
5. After changing the value push enter the scooter will beep – turn key switch off
and then on.
6. The programmer will display the next parameter. To make further changes
repeat step # 5
7. Press enter again to return to the parameter menu
8. When you get to the "Engineer Menu" press enter to get to the sub-menu
How to improve and to adjust parameters to the customer :
1. Change the accelerate of the scooter , forward .--- Line 1 .
2. Change the decelerate of the scooter , forward .--- Line 2
3. Change the accelerate of the scooter , reverse .--- Line 3.
4. Change the decelerate of the scooter , reverse .--- Line 4.
5. Change the max. speed - forward .--- Line 5 .
6. Change the max. speed – reverse .--- Line 7.
7. Change the direction of travel of the Wig-Wag. Invert Throttle --- Line 9 .
8. The time to enter to sleep mode when the key switch is "On" . Sleep
9. Reads the number of faults and how many times they occurred. Read
10. Working time of the scooter.Real timer . Line 12 .
11. Decelerate – soft stop.Line . 20 , 24 .
Timer . Line 10 .
System Log . Read System Log . Line 11 .
Adaptor to the Charger Socket
11