Assembly Instructions - Weston 05-0101 Manual

ASSEMBLY INSTRUCTIONS

FIGURE 1
1. Thoroughly clean the Fruit & Wine Press
before assembling and using it for the
first time to remove any residue that may
have accumulated during manufacturing
and shipping. Refer to the "CLEANING
Threaded
INSTRUCTIONS" section of this manual.
Shaft
Top Shaft Washer
2. Remove the Lower Retaining Nut and the
Bottom Shaft Washer from the Threaded
Base
Shaft.
3. Start the Set Screw into the hole on the
underside of the Base (FIGURE 2) do not
tighten all the way.
Lower Retaining Nut &
4. Insert the Threaded Shaft through the Top
Bottom Shaft Washer
Shaft Washer then through the opening in
the center of the Base (FIGURE 1).
Base
5. Tighten the Set Screw until snug using the
Set Screw
provided Allen Wrench (FIGURE 2).
6. Secure the Threaded Shaft to the Base
Allen
with the Bottom Shaft Washer and the Lower
Wrench
Retaining Nut (FIGURE 1).
FIGURE 2
7. Place each Basket Half Cage on the Base
forming a circle around the Threaded Shaft
and couple the hinges (FIGURE 3).
FIGURE 3
8. Secure the Basket together by inserting a
Basket Locking Pin into each hinge (FIGURE
4).
9. Insert the threaded end of the Lever
Handle into the Lever Mechanism (FIGURE
5).
Basket
Locking
Pins
Lever
Handle
Lever
Mechanism
FIGURE 5
FIGURE 4
6