HomeMatic HmIP-BPS Installation And Operating Manual page 28

Start-up
• Secure the power supply unit to the flush-
mounted box using the provided screws. Please
note that the arrow on the power supply unit has
to point upwards.
• Insert the desired device in the dimension of 55 x
55 mm (e.g. a Homematic IP Wall-mount Remote
Control) into the frame of the power supply unit
(see fig. 3). Make sure that the spring latches (A)
snap into the openings on the device.
The arrow(s) of the fixed device should also point
upwards to ensure clear assignment of channels.
• Switch the fuse of the power circuit back on
again.
Please refer to the corresponding operating man-
ual of the inserted device for further information
on integration into the Homematic IP system.
28