Jon-Don EZ SPOT Safety, Operation And Maintenance Manual With Parts List

Jon-Don EZ SPOT Safety, Operation And Maintenance Manual With Parts List

3-gallon extractors
Hide thumbs Also See for EZ SPOT:

Advertisement

New Equipment Warranty
Limited Warranty
Jon-Don, Inc. warrants new equipment against defects in material and workmanship
under normal use and service to the original purchaser. Any statutory implied
warranties, including any warranty of merchantability or fitness for a particular
purpose, are expressly limited to the duration of this written warranty. Jon-Don,
Inc. will not be liable for any other damages, including but not limited to indirect or
special consequential damages arising out of or in connection with the furnishing,
performance, use or inability to use the machine. This remedy shall be the exclusive
remedy of the purchaser. The warranty period is subject to the conditions stated
below.
Lifetime Warranty on Body, 5 Years on Vacuum Motors and Pump,
2 Years on Heater, 1 Year on All Electrical Parts, 90 Days on Tools
and Accessories
Jon-Don, Inc. warrants the roto-molded body to be free from defects in material and
workmanship, under normal use and service for a lifetime. Jon-Don, Inc. warrants
the motors and pump to be free from defects in material and workmanship, under
normal use and service for five (5) years from the original date of sale, heater for
two (2) years and all electrical parts one (1) year. Parts replaced or repaired under
this warranty are warranted for the remainder of the original warranty period.
Service labor charges are covered for one (1) year from the date of purchase, when
performed by a Jon-Don Repair Center.
Labor is only provided by a Jon-Don Repair Center. If a Jon-Don Repair Center is
not near you, it is the purchaser's responsibility to take their machine to a Jon-Don
Repair Center.
Normal wear items, such as capacitors, cords, finishes or switches, will be warranted
for manufacturing defects for ninety (90) days from the purchase date.
All warranties of motors and associated components will be voided: if the machine
is serviced by anyone other than a Jon-Don Repair Center; if the machine is
mechanically modified; if the machine is operated when not operating properly; or if
the machine is misused or abused.
The warranty starts on the purchase date by the original purchaser from Jon-Don,
Inc. subject to proof of purchase. The Machine Registration Card must be completed
and returned immediately at the time of purchase. If proof of purchase cannot be
identified, the warranty start date is ninety (90) days after the inventory stocking
date at the distributor's warehouse.
400 Medinah Road, Roselle, IL 60172
Phone: 800-556-6366 | Fax: 888-344-6878 | www.jondon.com
Make a copy of this card for future reference.
© 2016 All Rights Reserved Jon-Don, Inc.
Safety, Operation and Maintenance
Manual with Parts List
Please read before use!
3-Gallon Capacity
Important Information and Safety Instructions
Serial No:
© 2016 Copy Rights Reserved Jon-Don, Inc.
Manufactured with
Pride in the U.S.A.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the EZ SPOT and is the answer not in the manual?

Questions and answers

Summary of Contents for Jon-Don EZ SPOT

  • Page 1 Service labor charges are covered for one (1) year from the date of purchase, when performed by a Jon-Don Repair Center. Labor is only provided by a Jon-Don Repair Center. If a Jon-Don Repair Center is not near you, it is the purchaser’s responsibility to take their machine to a Jon-Don Repair Center.
  • Page 2: Warranty Registration

    Serial No. representative Should you have any questions regarding maintenance, replacing parts or ordering parts, please call your Jon-Don representative. Place of Purchase Before you begin using your EZ Spot Extractor, please thoroughly review the Owner’s Shipped To Manual. Your Name...
  • Page 3: New Equipment Warranty

    Distributor Phone No: Labor is only provided by a Jon-Don Repair Center. If a Jon-Don Repair Center is not near you, it is Date of Purchase: the purchaser’s responsibility to take their machine to a Jon-Don Repair Center.
  • Page 4: Safety Instructions

    • DO NOT turn heater on until the heater is full of water. Loss of vacuum • NEVER run the vacuum only with the pump on for more than 3 minutes. Water/ • Make sure the float is at the bottom of the unit. Open the screw cap and push the float solution needs to run through pump at all times to keep the pump cool while in use. down. Failure to do so will void the warranty. • Check that the hose cuff is securely attached to the front of the extractor. • Be sure to replace any filters back into the machine prior to use. • Do not use citrus acid, buterol or harsh degreasers inside the machine. Loss of solution pressure • Verify that the pump is on. Remove jet from end of hand tool and press trigger on wand. • Clean the solution intake in the solution tank. Check quick-disconnect for debris. • If pump is still not working, seek authorized repair services. (4) 3-Gallon EZ Spot Extractor Series 3-Gallon EZ Spot Extractor Series (13)
  • Page 5: Maintenance

    8” Black Hose for Stainless Steel Hand Tool 1.00 10-0506 Valve Clamp for Stainless Steel Hand Tool 1.00 10-0504 Valve for Stainless Steel Hand Tool 1.00 10-0502 Jet for Stainless Steel Hand Tool 1.00 (12) 3-Gallon EZ Spot Extractor Series 3-Gallon EZ Spot Extractor Series (5)
  • Page 6: Grounding Instructions

    Motor Mount Plate for Spotter 1.00 10-0354 3 Gallon Spotter Motor 1.00 10-0386 Stamped Motor Screen 1.00 10-1030 Spotter Motor Gasket 1.00 10-0027-A Strain Relief Nut 1.00 T-WBLA Black Wire (6) 3-Gallon EZ Spot Extractor Series 3-Gallon EZ Spot Extractor Series (11)
  • Page 7 8.0 Machine Schematic Drawing - with Heat 5.0 Machine Schematic Drawing - no Heat (10) 3-Gallon EZ Spot Extractor Series 3-Gallon EZ Spot Extractor Series (7)
  • Page 8: Parts List

    1/8” Brass Female Coupler 1.00 10-0506 Valve Clamp for Stainless Steel Hand Tool 1.00 10-0504 Valve for Stainless Steel Hand Tool 1.00 10-0502 Jet for Stainless Steel Hand Tool 1.00 (8) 3-Gallon EZ Spot Extractor Series 3-Gallon EZ Spot Extractor Series (9)

Table of Contents