Authorized warranty replacement parts need to come directly from the manufacturer. Any use of any other parts will void warranty. The manufacturer and Jon-Don, Inc. do not reimburse for parts used by the client that were not supplied directly for the machine under warranty.
The warranty starts on the purchase date by the original purchaser from an authorized Jon-Don, Inc. distributor, subject to proof of purchase. The Machine Registration Form must be completed and sent to the original manufacturer at the time of purchase.
Clean or replace hose and/or filter and repeat the priming process. If you are having trouble with the pump, refer to the “Trouble Shooting Guide” section or contact the Jon-Don technical support team for advice or assistance.
If moisture does enter the vacuum motors, contact your local Jon-Don service center. To prevent moisture from damaging the vacuum motors during storage, empty the recovery tank and store with the lid open.
5.0 Maintenance Regular maintenance is required to keep your Prospector Carpet Extractor in proper working condition. Failure to properly maintain your machine could void warranty. Thoroughly clean all equipment and accessories after each use: • Rinse the solution and recover tanks with clean water. •...
Clean Pump Inlet Filter CAUTION: before proceeding with this procedure, make sure both the power cords are disconnected. • To examine the filter, open the solution tank lid on the front of the machine. The filter is in the bottom of the solution tank.
6.0 Storage and Freeze Protection You must winterize your Prospector Carpet Extractor to protect the pump system from freezing and also damage being caused to fittings and valves. Damage due to freezing is not covered under the warranty. Store your extractor in temperatures over 40 degrees Fahrenheit.
7.0 Trouble Shooting Guide Never operate this Prospector Carpet Extractor when the equipment is not performing as expected or when any part is visibly damaged. When repair is needed, take the equipment to an authorized service center. System Problem Possible Cause Remedy Vacuum No Vacuum /...
9.0 Machine Parts List Drawing No. Item ID Item Description Qty. SN-12-ST-BLUGRAN 12-Gallon Solution Tank - Blue Granite 1.00 Part of Solution Tank Inserted Molded in to Solution Tank 80-0017 Bulk Head Fitting for Extractor 1.00 Part of 80-0017 Bulk Head Fitting 10-0845 1/4"...