Sharp DV-RW550U Service Manual page 47

Message
This program is not allowed
to be recorded on this disc.
This disc is protected and
not recordable.
Disc is full.
( No area for new recording )
You cannot record more
than 99 titles on one disc.
( The maximum is 99. )
You cannot record more than
999 chapters on one disc.
( The maximum is 999. )
You cannot record on this disc Delete unnecessary titles.
as Control Information is full.
You cannot record on the
disc as Power Calibration
Area is full.
This disc is already
finalized.
Can not record on this disc. Repeat the same operation.
If an error occurs during the timer recording, one of the following error numbers (40 to 42) or the above error messages
(error number: 1 to 39) is displayed on the recording menu after timer recording.
(Once the screen of the program line is exited, the program line for the error will be cleared.)
(No Error Message is displayed for the error No. 40 ~ 42.)
A program with the error number is grayed out and asterisked on the timer programming list.
Message
Error message is not
displayed.
Solution
Insert a ver.1.1 CPRM
compatible DVD-RW disc.
Release the disc protect setting
in the Disc Setting menu.
Insert the recordable disc with
enough recording space.
Delete unnecessary titles.
Delete unnecessary chapter
markers.
Insert a new disc.
Release the finalizing for this
disc.
Timer Programming
Date Start
* JAN/01 12:57AM
2. ---
3. ---
4. ---
5. ---
6. ---
7. ---
8. ---
Solution
- Set the timer programming
correctly.
- Set the timer programming
before the start time.
- Insert a recordable videotape
with a record tab.
Turn the power on and set the
clock correctly then set timer
programming again.
Insert the recordable disc.
Error
Error Description
No.
During the CGMS picture ( possible a record
once ) input. ( Disc which there is not for the
28
correspondence to VR Format CPRM )
29 Disc Protected Disc.
30 There is no it in a space field.
It is recorded a 99 title. ( Video Format Disc )
31
It is recorded a 99 title. ( VR Format Disc )
32
There is 999 number of total chapter.
33
( VR Format Disc )
There is not a space to a record field of
34
control information.
PCA Full. ( in REC start )
35
It is done Finalize. ( Video Format Disc )
36
37 Access to Memory Area range outside.
38 Sector Address is wrong.
39 BUP writing error of chapter editing.
VCR DVD
End CH DVD Speed
VCR
1:57AM 8 DVD E40 The speed mode changes
to the error number.
Error
Error Description
No.
- Some portion has not been recorded
because of program overlapping.
- Recording did not start at the start time.
40
- No Videotape is inserted.
Videotape ran out during recording.
41 Power failed
No disc when recording
42
1-12-3
Priority
12
7
5
7
8
9
10
4
6
-
-
-
Priority
-
-
-
E9656FIS