Configuration Example (On A Dhcp Server) - HPE FlexNetwork HSR6600 Security Configuration Manual

Step
1. Enter system view.
2. Enter interface view.
3. Enable authorized ARP on
the interface.

Configuration example (on a DHCP server)

Network requirements
As shown in
server) to ensure user validity.
Figure 162 Network diagram
Configuration procedure
1. Configure Device A:
# Specify the IP address for GigabitEthernet 1/1/1.
<DeviceA> system-view
[DeviceA] interface gigabitethernet 1/1/1
[DeviceA-GigabitEthernet1/1/1] ip address 10.1.1.1 24
[DeviceA-GigabitEthernet1/1/1] quit
# Configure DHCP.
[DeviceA] dhcp enable
[DeviceA] dhcp server ip-pool 1
[DeviceA-dhcp-pool-1] network 10.1.1.0 mask 255.255.255.0
[DeviceA-dhcp-pool-1] quit
# Enter Layer 3 Ethernet interface view.
[DeviceA] interface gigabitethernet 1/1/1
# Enable authorized ARP.
[DeviceA-GigabitEthernet1/1/1] arp authorized enable
[DeviceA-GigabitEthernet1/1/1] quit
2. Configure Device B:
<DeviceB> system-view
[DeviceB] interface gigabitethernet 1/1/1
[DeviceB-GigabitEthernet1/1/1] ip address dhcp-alloc
[DeviceB-GigabitEthernet1/1/1] quit
Verifying the configuration
# Display authorized ARP entry information on Device A.
[DeviceA] display arp all
Type: S-Static
IP Address
Command
system-view
interface interface-type
interface-number
arp authorized enable
Figure 162, configure authorized ARP on GigabitEthernet 1/1/1 of Device A (a DHCP
D-Dynamic
MAC Address
O-Openflow R-Rule
SVID Interface
550
Remarks
N/A
N/A
By default, authorized ARP is disabled.
M-Multiport I-Invalid
Aging Type