Midea MFA-12HRN1 General Information Manual page 59

MCAC-UTSM-2009-03
1. Wireless remote controller R51D/E
1.1 Remote Controller Specifications
Model
Rated Voltage
Lowest Voltage of CPU
Emitting Signal
Reaching Distance
Signal Range
Environment
1.2 Introduction of Function Buttons on the Remote Controller
1. : Press the button to decrease the indoor temperature setting.
TEMP Button
2. : Press the button to increase the indoor temperature setting.
TEMP Button
3. ON/OFF Button: Push this button to start the unit operation. Push the button again to stop the unit
operation.
4. MODE Select Button: Each time you push the button, a mode is selected in a sequence that goes from
AUTO、COOL、DRY、HEAT and FAN, as the following figure indicates:
5. SWING Button: Push this button, the louver would swing up and down automatically. Push again to stop it.
6. RESET Button: When the RESET button is pushed, all of the current settings are cancelled and the
control will return to the initial settings.(Use a φ1mm little round stick to push the button )
7. AIR DIRECTION Button: Push this button, the louver can be fixed at a desired angle. The louver swing
(upward or downward) to a certain angle for each press. When the louvers swing at an angle which
would affect the cooling and heating efficiency of the air conditioner, it would automatically change the
swing direction (upward or downward).
8. FAN SPEED Button: This button is used for setting Fan Speed in the sequence that goes from AUTO,
LOW , MED to HIGH, then back to Auto.
Control
R51D/E R51D/CE
，
3.0V(Alkaline dry batteries LR03 2)
2.0V
8m (when using 3.0 voltage,
it Gets 11m)
。
-5 C 60 C
1
SET TEM PERATURE
4
AUT O
COOL
D RY
HEA T
TE MP.
5
ON/OF F FAN S PEE D
MODE
SWING ECONOMIC TI MER ON
TI MER OFF
RE SET L OCK
AI R DIRECTION
6
7
Wireless remote controller R51D/E
。
2
（ O C)
8
FAN
H IGH
MED
LOW
3
9
10
POWE RFUL
11
12
13
×
57