Replacing The System Board; Procedure - Dell Inspiron5675 Service Manual

Identifier
Status

Replacing the system board

WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
working inside your
the instructions in
practices, see the Regulatory Compliance home page at
regulatory_compliance.
NOTE: Your computer's Service Tag is stored in the system board. You must
enter the Service Tag in the BIOS setup program after you replace the
system board.
NOTE: Replacing the system board removes any changes you have made to
the BIOS using the BIOS setup program. You must make the appropriate
changes again after you replace the system board.
Identifier
Status

Procedure

1 Align the system board with the slots on the chassis and place the system board
in position.
2 Replace the eight screws (6-32UNCx6.3) that secure the system board to the
chassis.
3 Route the front-audio cable, fan cable, processor-power cable, power-button
board cable, power-supply unit cable, USB 2.0 cable, USB 3.0 cable, optical-drive
power cable, hard-drive cables, and USB 3.1 Type-C port cable (optional) through
their routing guides and connect the cables to their respective connectors on the
system board.
GUID-67274E98-E2F1-4B7B-A903-F38BA6B62028
Released
computer. After working inside your computer, follow
After working inside your
GUID-F12384DA-5A8B-4529-A93B-4618502A5B4A
Released
computer. For more safety best
www.dell.com/
Before
139