Kenmore 253.7034 Use & Care Manual page 9

Installation
CAUTION
Do Not loosen or remove these 3 hex
screws.
Cabinet Leveling & Refrigerator
Door Alignment (if necessary)
Guidelines for final positioning of your
refrigerator:
All four corners of the cabinet must rest
firmly on the floor.
The front should be slightly elevated to
ensure that doors close and seal properly.
Doors should align with each other and
be level.
Most of these conditions can be met by
raising or lowering the adjustable front
rollers.
To level the cabinet using the front rollers:
1 Slightly open freezer drawer if the
toe grill is installed. Lift the toe grille
and gently pull forward.
2 Make initial cabinet adjustments by
using the front roller height adjusting
screws. Use a 3/8 inch socket wrench
to turn the adjustment screws (1 per
side).
To raise: turn adjustment screw clockwise.
To lower: turn adjustment screw
counterclockwise.
3 Ensure both doors are bind-free with
4 After unit is leveled, lower anti-tip leg
DO NOT
Loosen
or
Remove
These 3
Hex
Screws
5 Install the toe grille by fitting into
9
their seals touching the cabinet on all
four sides and that cabinet is stable.
using a 3/8 inch socket wrench until it
firmly contacts the floor.
Door
Raise
Anti-tip
Leg
Lower
place.
Toe Grille Must
Fit in Slot on
Anti-tip Bracket
Screw/Washer
Assembly
(3) Retaining Clips
Door