Storage Features - Kenmore 253.7034 Use & Care Manual

Storage Features

CAUTION
To avoid personal injury or property
damage, handle tempered glass
shelves carefully. Shelves may break
suddenly if nicked, scratched, or
exposed to sudden temperature
change. Allow the glass shelves to
stabilize to room temperature before
cleaning. Do not wash in dishwasher.
NOTE
Features may vary according to model.
Your refrigerator includes Spill-Proof
glass shelves that are designed to catch
and hold accidental spills.
You can easily adjust shelf positions
in the fresh food compartments to suit
your needs. The shelves have mounting
brackets that attach to slotted supports at
the rear of each compartment.
IMPORTANT
Be aware of the air seal located at
the rear of the shelf. Shelves located
on the left side should have the air
seal mounted on the far left side.
Shelves located on the right side should
have the air seal mounted on the far
right side. This is to ensure there is no
interference with the large air tower on
the back wall of the cabinet. This also
applies to the crisper shelves.
Full Spill-Proof
TM
TM Shelf
24
Half Spill-Proof
Change the Position of a Shelf
1 Remove all food from shelf.
2 Lift the front edge up and pull the
shelf out.
3 Replace by inserting the mounting bracket
hooks into the desired support slots.
4 Lower the shelf and lock into position.
Reposition the Air Seal
For slide-out shelves & crisper shelves:
1 Remove air seal by pushing down on
the flap with a downward rotation.
2 Position the air seal towards the outside
end of the shelf to avoid the air tower
when shelf is pushed back into place.
3 Install seal by sliding lower tab of seal
up into bottom rear slot of shelf with
seal at a downward angle then pulling
up on seal flap until seal sits snug on
back of shelf and flap sits at about a
10 degree angle from shelf surface.
TM Shelf