Kenmore 253.7034 Use & Care Manual page 31

Changing the Filter
Locating the Filters
Your refrigerator is equipped with water
filtering system. The water filter system filters
the water used to produce ice.
Water Filter
The water filter is located at the top right
side of the fresh food compartment.
Replacing the Water Filter
In general, you should change the water
filter every six months to ensure the highest
possible water quality. Water Filter Status
on the user interface prompts you to replace
the filter after a standard amount of water
(200 gallons/757 liters for Kenmorepure!
has flowed through the system.
If your refrigerator has not been used
for a period of time (during moving
for example), change the filter before
reinstalling the refrigerator.
Filter Cartridge
Ordering Replacement Filters
To order your replacement filters, please
visit the dealer where you purchased your
refrigerator. Sears recommends that you
order extra filters when you first install your
refrigerator, and that you replace your filters
at least once every six months.
Here is the product number to request
when ordering:
Kenmorepure!
Part #046-9999
NOTE
When ordering your replacement filter,
please reorder the same filter type that is
currently in your refrigerator.
TM
Water Filter
TM
More about your Advanced Water Filter
The Kenmorepure!
filter system is tested and certified to
NSF/ANSI Standards 42 and 53 for
the reduction of claims specified on
the performance data sheet.
Do not use with water that is
microbiologically unsafe or of unknown
quality without adequate disinfection before
or after the system. Systems certified for
cyst reduction may be used on disinfected
waters that may contain filterable cysts.
Test & Certification Results:
• Rated Capacity - 200 gallons/757 liters
)
for Kenmorepure!
• Rated service flow - .50 gallons per minute
• Operating Temp.: Min. 33°F, Max. 100°F
• Maximum Rated Pressure - 100 pounds
per square inch
• Recommended Minimum Operating
Pressure: 30 pounds per square inch
To Replace your Kenmorepure!
Water Filter:
It is not necessary to turn the water supply
off to change the filter. Be ready to wipe up
any small amounts of water released during
the filter replacement.
1. Turn Off ice maker.
2. Remove the filter by pushing on the end/
face of the filter.
3. Slide the old water filter cartridge straight
out of the housing and discard it.
4. Unpackage the new filter cartridge. Using
the alignment guide, slide it gently into the
filter housing until it stops against the snap-
in connector at the back of the housing.
5. Push firmly until the cartridge snaps into
place (you should hear a click as the
cartridge engages the snap-in connector).
6. Turn On ice maker.
7 . To reset the water filter on your IQ-Touch
control, press and hold the water filter
icon for three seconds. When the display
changes from Red to Green, the status
has been reset.
31
ice and water
TM
ice and water filter
TM
TM