Daewoo KOC-910K0P Service Manual page 14

4. Method to reduce the gap between the door seal and the oven front surface.
(1) To reduce gap located on part 'A'
Loosen two screws on stopper hinge top, and then
push the door to contact the door seal to oven front
surface.
Tighten two screws.
(2) To reduce gap located on part 'B'
Loosen two screws on stopper hinge under, and then
push the door to contact the door seal to oven front
surface.
Tighten two screws.
NOTE : A small gap may be acceptable if the microwave leakage does not exceed 4mW/cm
A
B
13
2 .