Table of Contents
Advertisement
Chapter 10. Recording Settings
10.3. Frequency
Choose the recording frequency (sample rate).
48 kHz, 44.1 kHz, 32 kHz, 24 kHz, 22.05 kHz, 16 kHz, 12 kHz, 11.025 kHz and 8 kHz are
available. Higher sample rates use up more disk space, but give better sound quality.
Note: The 11.025 kHz setting is not available when using MPEG Layer 3 format.
10.4. Source
Choose the source of the recording. The options are: Microphone and FM Radio.
For more information on recording from the radio see section
10.5. Channels
This allows you to select mono or stereo recording. Please note that for mono recording,
only the left channel is recorded. Mono recordings are usually somewhat smaller than
stereo.
10.6. Mono Mode
When configured to record to mono and the source is a stereo signal, use this setting to
configure how the mono signal is created. Options are L, R and L+R.
10.7. File Split Options
This sub menu contains options for file splitting, which can be used to split up long
recordings into manageable pieces. The splits are seamless (frame accurate), no audio is
lost at the split point. The break between recordings is only the time required to stop
and restart the recording, on the order of 2 – 4 seconds.
Split Measure. This option controls whether to split the recording when the Split
Filesize is reached or when the Split Time has elapsed.
What to do when Splitting. This controls what will happen when the splitting condi-
tion is fulfilled the two available options here are Start a new file or Stop
recording.
Split Time. Set the time to record between each split, if time is used as Split Measure.
Options (hours:minutes between splits): Off, 00:05, 00:10, 00:15, 00:30, 1:00, 1:14
(74 minute CD), 1:20 (80 minute CD), 2:00, 4:00, 8:00, 10:00, 12:00, 18:00, 24:00.
Split Filesize. Set the filesize to record between each split, if filesize is used as Split
Measure.
The Rockbox manual
(version 3.14)
96 kHz, 88.2 kHz, 64 kHz,
5.9
(page 49).
Sansa Fuze+
89
Advertisement
Table of Contents
