Advertisement
Setting Room Temperatures
Temperatures can be set with either the B key or in the BASE menu.
Menu 1
BASE
Press the
key. You should see:
TIMER
Use this line to set the timer. Press the
DAY1
NITE1 SAVE1 These are room settings for the day, night, and long term setback mode. Even if you
are not using room sensors, set these values. From the difference between the day & night settings the TC204
calculates how much it should set the reset schedule back at night.
If you are not using night setback, set them all at the same value.
Display Temperatures
Menu 1
Base
R1
Readout of room temperature
OUTD
Readout of outdoor temperature
O.MIN
Lowest outdoor temperature since the last time this value was reset.
WAT.
Supply water temperature
WAT2
Return water temperature
If the sensor is not connected, the value, and in some cases, the symbol does not appear.
Setting the Clock
Menu 1
BASE
Use the
key to scroll to a line for time that looks like this:
02:35
Two dots between hr:min mean am, three dots pm
WED
Use the UP or DOWN key to make a value flash; change it with the
key, & change it with the
through the menu with the
You can use 12 hour time or 24 hour military time. Make the selection in Menu 12. Also, you can set changeover
between standard time and daylight savings time in menu 12.
The next line for date looks like this:
10.04
(day.year)
JAN.
Use the UP or DOWN key to make a value flash and change it with the
the
Key and set it with the
To select the menus, use the
When you get to the value you want to set, make it flash with the
keys. After you make the change, press
keys. Use the
key until all values stop flashing. You can scroll backwards
key.
Keys.
keys. When you get to the menu you want, step through it with the
again to move to the next value.
key again.
keys. Scroll to the next value with the
keys. Scroll to the next value with
keys and then change it with the
9
keys.
Advertisement
