Advertisement
Setting Times
Times are set with a weekly program in which the Day, Night, and Economy cycles begin at set times on
programmed days of the week. Optimized warm-up for the day cycle is also set in the Weekly Program.
Date Programs, in which a cycle is programmed to begin and end on specific dates and hours, override the
Weekly Program.
Weekly Program
Menu 2
W.PR.
WPno
1 or 2
There are two weekly programs. The Weekly Program set in this line is the active one for Day, Night, and
economy modes.
The Weekly Program for the auxiliary output is selected in the auxiliary output menu. The Weekly Program can
be the same for both applications.
Set values in both weekly programs by setting this line for one program, filling it in, and then resetting this line to
the other program and filling it in. Remember to reset this line to the Weekly Program you want active for day/
night programming.
Each Weekly program has 6 events that can be filled in. The data for each event is the time of day, days of the
week, and Day, Night, or Economy mode.
Times can be set at ten minute intervals. In 12 hour time PM is indicated by 3 dots between hours & minutes.
Days of the week are at the lower left of the screen in a row of 7 dots or vertical lines. Monday is day 1 and
Sunday is day 7. A vertical line means initiate a cycle on that day at the time shown.
The event number, 1 - 6, precedes the day indicator.
The symbol at the upper left of the screen shows the cycle that is going to start.
The Sun symbol indicates Day mode.
The Moon symbol indicates Night mode.
Both symbols together indicate economy mode.
When the control is running, the symbols show which mode it is in. If the symbol is flashing, the timer is running.
For example, This screen shows that event
#1 initiates a Day cycle Monday through
Saturday at 7:00 am.
This screen shows that event #2 initiates
a Night cycle Monday through Friday at
5:00 PM.
This screen shows that event #3 initiates a
Night cycle Saturday afternoon at 1:00 PM.
.
Step through the event with the RIGHT key and change the flashing value with the
done with an event and nothing is flashing, you advance to the next event with the
When you are using a room sensor, set the times for day cycles to the time of occupancy; do not allow for
warm-up because this is done with optimization. (next line)
.
7:00
1
..
5:00
2
3
10
.
.
1:00
keys. When youʼre
key.
Advertisement
