Advertisement
The menus are:
BASE
1
W.PR.
2
Weekly Program
D.PRO
3
Date Program
X.OUT
4
Extra Output
LOG
5
Log Values
REGUL
6
Control parameters
RET.R
7
Return
CURVE
8
Curve selection
RET.R
9
Outputs
INPUt
10
Inputs
PUMP
11
Pump Control
CAL
12
Calibration
BUT.F
13
Button Functions
Test
14
Test
TYPE
15
TYPE
KOMM
16
Communication
Set the Date, Time, Temperatures, and Timer function. Readouts
There are 6 time periods that can be set to begin a day, night,
or economy period. Each time can be set to begin on any day
or combination of days of the week.
There are 8 dates that can be set so that four different day, night,
or economy periods can be set to begin and end in advance.
A date setting overrides a weekly setting.
This is an output that can be activated by temperature and/or time.
Running log of the outdoor temperature (or room temperature if it
is connected) for up to 96 events at intervals of up to 255 minutes.
Minimum & maximum supply temperatures, proportional bands and
integral times
Sets the minimum return water temperature
Select the outdoor curve.
Control type, outdoor cutoff temperature
External contact function, internal sensor
The pump can be controlled by outdoor or supply water temperature.
Adjustment of the sensors to compensate for small errors in the sensor
or to compensate for the length of wire to the sensor. Adjust the clock
speed if it is running fast or slow, set the beginning and end of
daylight savings time, and set the clock for 12 or 24 hour time.
Set temperatures in Fahrenheit or Celsius.
Security, locking, limits on settings, display
Manually operate outputs, simulate temperatures, set security code
This displays data about this particular controller. There are no
programmable functions.
ModBus
12
Advertisement
