Page 1
Conforms to ECE R44/04 milan milan z e s t user guide EXTREME HAZARD: Parents should not under any circumstances use this child restraint on a passenger seat equipped with an airbag. IMPORTANT ! KEEP FOR FUTURE REFERENCE FC7715A...
Page 2
safety warnings PLEASE READ THOROUGHLY BEFORE COMMENCING INSTALLATION AS AN INCOR- RECT INSTALLATION COULD BE DANGEROUS. DO NOT USE THIS CHILD SEAT IN PASSENGER SEATS EQUIPPED WITH AIRBAGS. This child seat must only be installed in a forward facing position in passenger seats.
Page 3
Your seat cover may be supplied seperately to the plastic shell. To fit the cover to the shell, start first with the plastic base and base cover. From the front, slide the cover onto the shell making sure you slide the cover over the arms of the shell.
Page 4
important notes This user guide should be stored under the seat cover of the base. When the child seat is not in use, it is recommended that it is fastened into the car with a seat belt to avoid being thrown about in the event of an accident. If you travel with passengers using both the front and rear seats, the lighter oc- cupants should be in the rear seats and the heavier occupants in the front of the vehicle.
Page 5
fitting your child seat into your car Group 3 - To set up for use from 22kg to 36kg fig 1 The child seat can be used as a ‘booster seat’ for children over 22kg by removing the back section of the seat.
Page 6
IF YOU ARE UNSURE ABOUT THE FIT OF YOUR CHILD SEAT, PLEASE VISIT YOUR LOCAL MOTHERCARE STORE FOR ADVICE. seat assembly and returning to high back configuration TO ASSEMBLE THE SEAT AFTER YOU HAVE FITTED YOUR ZEST COVER FOLLOW THE GUIDELINES BELOW.
The safety of this seat may be compromised by the use of accessories not approved by mothercare. The replacement parts listed below are available for your product. In the event that you require any of these parts, please contact your local mothercare store or contact Customer Care on 08453 30 40 30.
Page 8
4. If in doubt, consult either the child restraint manufacturer or the retailer. 5. Only suitable if the approved vehicles are fitted with 3 point static or retractor safety belts approved to UN/ECE Regulation No.16 or other equivalent standards. Made in France for Mothercare, Watford, Herts, WD24 6SH Issue 1 - 08-10...
Need help?
Do you have a question about the Milan and is the answer not in the manual?
Questions and answers