Summary of Contents for mothercare 2 in 1 booster seat
Page 1
2 in 1 booster seat user guide IMPORTANT. KEEP FOR FUTURE REFERENCE...
Page 2
introduction This two height booster seat is designed to be fitted to a suitable chair*, to raise the height of your child when sat at a table. WARNING: It is recommended that the booster seat be used in the upright position only by children capable of sitting upright unassisted (around six to nine months).
Page 3
preparation for use the securing strap fig 4 1. Disengage the buckle of the securing strap by squeezing the fastner prongs and pulling apart. fixing the seat to the base fig 5 Place the upper seat onto the base as shown, and press down firmly.
Page 4
preparation for use fixing the seat to the base fig 6 Ensure that the upper seat is securely engaged with the base. Firm clicks will be heard from both sides of the booster seat once product is secured. fixing to the chair fig 7 Position the booster on the chair*, wrap the securing strap...
Page 5
in use the harness fig 9 To fasten Insert both fasteners securely into their respective clasps fig 10 Adjust the waist strap length by pulling on the free end to remove unwanted slack fig 11 To release Squeeze the fastener prongs and pull apart.
Page 6
in use adjusting the height fig 12 The height of the booster can be adjusted for taller & older children by removing the base. Release the clips at both sides of the seat and lift the upper seat off the base. The upper seat can then be used on a seat by securing as described on page 3.
Page 7
If the booster is used by someone unfamiliar with it e.g. grandparents always show them how it is used. Never leave your child unattended, even for the shortest time. Mothercare UK Ltd., Cherry Tree Road, Watford, WD24 6SH Customer care line Tel: 08453 30 40 30...
Need help?
Do you have a question about the 2 in 1 booster seat and is the answer not in the manual?
Questions and answers