Replacing Your Foil And Cutters; Signs That Your Foils And Cutters Need Replacing; To Replace The Foil; To Replace The Cutters - Remington WDF4840 Instructions Manual

• Do not rinse with water hotter than 70°C.
• Do not completely submerge the lady shaver in water.
• Do not clean the shaving foils with the brush.
• At regular intervals, put a drop of sewing machine oil onto the foils and
cutter heads.

, Replacing your Foil and Cutters

To ensure the continued highest quality performance from your shaver, we
recommend that the foil and cutter are replaced every 6 months. These can
be obtained from our nearest Remington* Service Centre.

, Signs that your foils and cutters need replacing:

• Irritation: As foils get worn, you may experience skin irritation.
• Pulling: As the cutters wear, your shaver may not feel as close and you may
feel he cutter pulling your hair.
Wear through: You may notice that the cutters have worn through the foils.
•

, To Replace the Foil

• Ensure the lady shaver is switched off.
• Gently push the small plastic area at either end of the foil. The foil should
then easily detach from the head assembly.
• To reassemble, slide the foil into foil bracket and click into position.
• Close the head assembly.
, CAUTION
• Only hold the plastic to prevent damage to the foil.
• Do not press on the foil when replacing.

, To Replace the Cutters

• Ensure the shaver is switched off and open the head assembly (as above).
• To remove cutter, grasp cutter between the thumb and forefinger and pull
upwards.
• To reassemble cutter, place cutter onto the oscillator tip. Gently push down
clicking into position.

BATTERY REMOVAL

• The battery must be removed from the appliance before it is scrapped.
• The appliance must be disconnected from the supply mains when removing
the battery.
• Remove the shaver head from the unit.
6