Endress+Hauser FMX 570 Operating Instructions Manual page 14

Silometer FMX 570
Fig. 2.5:
Layout of Monorack terminal
blocks
Monorack wiring
12
Power
PC board
slot
Insert coding pins
for Z-version at
Positions
2 and 9
Input, d2, d4
Fig. 2.5 shows the layout in the base of the Monorack II housing, the pin assignments
correspond to those in Fig. 2.4. When connecting together several Monoracks, follow
the instructions supplied with the housing.
• Set the jumper to position "Racksyst I"
• Insert the coding pins supplied at positions 2 and 9 in the female connector
at the base of the housing.
• The pin assignments printed in black are valid for the Silometer FMX 570.
Note!
If you are installing the Silometer FMX in a Monorack I housing, please note that there is
no jumper switch. In addition, for the 24 VDC version, the dummy card in the power
control slot must be replaced by the 24 V card supplied.
Chapter 2: Installation
Hole for mounting
screw
Outputs
see Fig. 2.4
Jumper positioned
for Racksyst I card
Hole for mounting
screw
BA119E14