Wire And Cable Specifications - Panasonic LST 116 Installation And Operating Instructions Manual

4. Installation

4.5 Wire and cable specifications

Wiring run
Lobby station
Power supply unit
Power supply unit
Lobby station
Note the following when selecting wiring
R For all wiring (except network wiring), use 2-conductor (solid copper) wiring with a PE (polyethylene)-insulated
PVC jacket.
Mid-capacitance, non-shielded wiring is recommended.
R A certified power supply wiring has to be used with this equipment. The relevant national installation and/or
equipment regulations shall be considered. A certified power supply wiring not lighter than ordinary polyvinyl
chloride flexible wiring according to IEC 60227 shall be used.
22
«
Switching hub
«
Lobby station
«
AC power source
Electric lock
«
Access controller
Open door sensor
Specifications
Cat-5e or higher, stranded,
twisted pair, straight
0.65 mm (22 AWG)
2 mm (12 AWG)
1.2 mm (17 AWG)
2 mm (12 AWG)
0.5 mm (24 AWG)
1.2 mm (17 AWG)
Max. length
100 m
approx. 10 m
approx. 20 m
No requirement
According to specification
of connected device.